Roof flashing
Step, counter and kickout flashing plus new pipe boots instead of reusing old metal.
Roof Replacement
Roof Installation Newton, NJ
A roofer in Newton can install a new roof in the proper sequence: drip edge, ice and water shield, underlayment, starter strip, flashing, vents and then the roofing itself, because the details at edges, walls and valleys decide whether it leaks. Dial (973) 858-9950 to talk with a local roofer about installation.
When a fairly new roof leaks, the cause is usually how it was installed rather than what it was made of. Nails driven above the reinforced strip, flashing left out at a sidewall and short valleys are the kind of mistakes that show up within a few seasons. None of these are visible from the ground once the job is done.
Choosing the material comes first. Architectural, or dimensional, asphalt shingles are the most common choice on houses, with thinner three-tab shingles still used on some homes and sheds, while standing seam or exposed fastener metal, concrete or clay tile and slate each need their own methods and fasteners. The slope of the roof limits the options, because shingles need a minimum pitch and nearly flat sections need a membrane roof.
A Newton roofer will ask a handful of questions up front. Say whether the job is a tear-off, an addition or new construction, and whether you have a material or color picked out.
Many roof installation calls in Newton also turn up a need for roof replacement or shingle roof installation.
Looking for Newton roof installation? Call (973) 858-9950 to talk to a local roofer.
Call nowThe process
How roof installation works
Each layer protects the one under it, so the order is not optional.
Ready the decking
Before installation, the crew walks the decking and replaces soft or damaged sections. If the job is an overlay instead, the existing roof has to be flat enough to accept a new layer.
Protect the eaves
Drip edge goes on at the eaves, ice and water shield is rolled out along the eaves and in the valleys, and drip edge is then added along the rakes over the underlayment. Codes in colder areas often require the ice barrier to reach a set distance inside the exterior wall.
Lay the underlayment
The remaining deck is covered with underlayment, overlapped at the seams and fastened on the maker's pattern. It is the backup layer if a shingle is ever lifted or broken.
Install flashing
Step flashing is woven in with each course along sidewalls, counter flashing covers it at masonry, kickout flashing sits at the bottom of each wall line and new pipe boots go over every vent. Sealant is a backup, not the flashing itself.
Put down the roofing
After a starter course, the crew lays shingles row by row, keeping the exposure even and the nails inside the nail strip. Valleys are finished as open metal, closed cut or woven, depending on the material and the plan.
Finish the ridge
The crew opens a slot at the ridge for a ridge vent, or installs box vents, and finishes with cap shingles. Without enough soffit intake, a ridge vent cannot do its job.
What is included
Components of the installation
Ice barrier
Ice and water shield at the eaves and valleys, with underlayment over the rest of the deck guards the deck if ice dams form.
Ventilation
Ridge vents or other exhaust paired with soffit intake to keep heat and moisture moving out.
Metal edging
Metal edges around the whole roof keeps water off the fascia boards.
Roof covering
The finished roofing, installed to the maker's nailing and fastening pattern from the eaves up to the peak.
Related service
New Roof Installation Newton, NJ
A new roof installation can mean a roof on a stripped house, a roof on new framing or a roof on an addition tied into an existing one. Additions take extra care, because the new roof has to tie into the old one with matching shingles, woven or flashed valleys and step flashing where the new roof meets an existing wall. Ask whether the new section will match the existing roofing or whether the whole roof should be redone.
Manufacturers publish exact steps for their products, and local code usually requires following them. A Newton roofer should be able to explain how many nails per shingle will be used, what underlayment goes down and what ventilation the attic will have. Vague answers about the hidden layers are worth noticing.
Related service
Roof Overlay Newton, NJ
A roof overlay installs a new layer of shingles directly over one existing layer instead of tearing the old roof off. Building codes generally cap asphalt roofs at two layers, so an overlay is only possible on a roof with a single layer, and not over shingles that are badly curled, wet or sitting on soft decking. It means less mess and a faster install.
There are good reasons most roofers prefer a tear-off. Nobody can see or repair the decking, the old flashing tends to stay in place, the extra weight sits on the framing, and bumps in the old roof can telegraph through the new shingles. When an overlay is proposed, ask how they confirmed there is only one layer and how the flashing will be handled.
Local help
Roof Installation Near Me
Roof installation in Newton runs from full tear-offs on older homes to brand new roofs on additions and new houses. Across Newton and nearby places including Andover, Hopatcong, Allamuchy and Franklin, storms take the biggest toll on roofs that were installed with shortcuts, and a careful installation is what lets a new roof ride out years of weather.
For roof installation in Newton, NJ or nearby towns like Andover, Hopatcong, Allamuchy and Franklin, call (973) 858-9950 to reach a roofer who covers your street.
Roofs in this climate
Cold winters bring snow, ice and a long stretch of freezing nights. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, which is how ice dams form and back water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in Newton is busiest after a hard winter and before the next one.
Why call
Why not wait
Smaller repairs
Small roof problems caught early usually stay small repairs.
Familiar with local homes
Roofers in Newton know the roof types and weather wear common in local homes.
Know what happens next
Ask your questions before you agree to anything.
Common questions about roof installation
What type of roof should I install?
It comes down to pitch, budget, look and how long you want the roof to last. Architectural asphalt shingles suit most homes, metal lasts longer and sheds snow well, and tile or slate need framing that can carry their weight. A Newton roofer can lay out the trade-offs for your roof.
What goes under a new roof?
A new roof should have drip edge, ice barrier along the eaves and valleys and synthetic or felt underlayment everywhere else. Starter strip, step and kickout flashing and new pipe boots are also part of a proper installation.
Is a permit needed to install a new roof?
Requirements depend on where you live, but a permit is common for a full roof. The roofing contractor usually pulls it, and an inspector may check the work.
Can a roof be installed in cold weather?
Roofs can go on in cold weather with some extra steps. Asphalt shingles get brittle in the cold and their sealant strips need warmth to bond, so crews may hand seal shingles and store bundles somewhere warmer. Nobody should work on an icy or wet roof, so weather windows matter.
How long does it take to install a new roof?
Most homes are done in one to a few days. Larger, steeper or more cut-up roofs need more days.
More questions? Call (973) 858-9950
Often needed together
Roof Replacement
A complete new roof from the deck up when repairs no longer make sense, with the old layers removed and the deck checked.
Learn moreShingle Roof Installation
New shingle roofs built layer by layer on a sound deck, so the roof sheds water and handles wind from day one.
Learn moreMetal Roof Installation
Metal roof installation built around the right panel, finish and trim for the house, so the roof handles heat, wind and thermal movement.
Learn moreNew Construction Roofing
Getting new framing dried in fast and roofed to code, so the house is protected before interior work starts.
Learn more
Looking for something else?
See all roofing servicesTalk to a Newton roofer about roof installation
Call now for Newton roof installation and help in the towns around it.